10 inch, Dual Surface, 100%
Boar's Hair Wash Brush
What's a dual-surface brush? Picture washing a delivery van
or RV with a flat wash brush at the end of an extension handle. At the roof
line, the brush's block is parallel to the surface being scrubbed so all the
bristles are in contact with the surface. As you work down to about chest
height, the brush's bristles will be pointed at the ground and the edge of the
block will hit the surface you are trying to wash. If you want to wash lower
panels, you must switch from scrubbing up and down to scrubbing left and right.
What you need, is a brush that has an angled block with bristles on both
surfaces. That's what we have here with this 10 inch, Dual Surface, 100%
Boar's Hair Wash Brush. In effect, it's two brush surfaces on one brush. Now
you can continue to wash lower panels with a continuous up and down motion. This
is a particularly good brush for washing RV's, boats and delivery vans and
construction equipment.
Like our other boar's hair brushes,
this brush is made with 100% natural boar's hair and the hair bundles are glued
into the block. The 10 inch block is
resistant to acid, alkaline, detergents and is sized to fit inside the standard
wash bucket. One side of the block is threaded to accept any standard extension
handle such as our Pro-Pole (listed below) or flow-through extension poles.
| Because of the angled
block, there is no need to remove the brush head to hand wash lower panels.
The 3-1/2 inch bristles gently scrub away the worst road grime yet are
gentle to painted, clear coated and fiberglass surfaces.
When you're finished washing, rinse
the brush with free-flowing water and allow the brush to air dry. |
 |
Brush head only. See below for a specially-priced package of
this brush with our Pro-Pole.
Overall brush size is 10 inches by 3 inches by 5-3/4
inches high. |